Manual for EC Limiter II

Quick look at controls

  • "Load" button - to load configuration in specific to the plugin format
  • "Save" button - to save configuration
  • "Limiter" button - to turn effect on and off
  • "Sustain" knob - to tune sustain level
  • "Output" knob - to manage common output level
  • "Knee" knob - to manage compression softness
  • "Attack" knob - to setup attack time
  • "Release" knob - to setup release time
  • "Delay" knob - to change time delay between source signal and amplitude detector signal
  • "Limit highs" knob - apply limiting to the high frequency component
  • "Limit lows" knob - apply limiting to the low frequency component
  • "Amp. source" knob - choose amplitude source, lows or highs
  • "Split order" knob - choose splitting filters type - 1-st order or 3-rd order Butterworth
  • "Split at" knob - tune splitting frequency
  • "L/H" knob - to set up balance of detected amplitudes of lows and highs
  • "AD order" knob - amplitude detector low-pass filter order
  • "AD freq." knob - amplitude detector low-pass filter frequency


Authorize
E-mail
Password
register or restore